Siemens RUGGEDCOM ROX II User Manual page 742

Chapter 16
Traffic Control and Classification
1. Make sure the CLI is in Configuration mode.
2. Add the static MAC address by typing:
qos traffic-control basic-configuration tcpriority name
Where:
• name is the name of the traffic control priority entry
3. Configure the following parameter(s) as required:
Parameter
iptype { iptype }
band { band }
protocol { protocol }
port { port }
address { address }
interface { interface }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 16.2.3.3
Deleting a Traffic Control Priority
To delete a traffic control priority, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control priority by typing:
no qos traffic-control basic-configuration tcpriority name
Where:
• name is the name of the traffic control priority entry
696
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
Synopsis: { high, medium, low }
Default: medium
Priority (band) : high, medium, low... High band includes: Minimize Delay (md) (0x10),
md + Minimize Monetary Cost (mmc) (0x12), md + Maximize Reliability (mr) (0x14),
mmc+md+mr (0x16). Medium band includes: Normal Service (0x0), mr (0x04), mmc
+mr (0x06), md + Maximize Throughput (mt) (0x18), mmc+mt+md (0x1a), mr+mt+md
(0x1c), mmc+mr+mt+md (0x1e). Low band includes: mmc (0x02), mt (0x08), mmc+mt
(0x0a), mr+mt (0x0c), mmc+mr+mt (0x0e).
Synopsis: { tcp, udp, icmp, all } or a string
(choice) A targeted protocol.
Synopsis: A string
(choice) Source port - can be specified only if protocol is TCP, UDP, DCCP, SCTP or UDPlite
Synopsis: A string
(choice) The source address. This can be specified only if the protocol, port and interface
are not defined.
Synopsis: A string 1 to 15 characters long
(choice) The source interface. This can be specified only if the protocol, port and address
are not defined. Lowercase alphanumerical as well as '.' and '-' characters are allowed.
Synopsis: A string
(optional) A description for this configuration.
Description
Deleting a Traffic Control Priority
RUGGEDCOM ROX II
CLI User Guide