Siemens RUGGEDCOM ROX II User Manual page 431

RUGGEDCOM ROX II
CLI User Guide
Parameter
high-value { high-value }
IMPORTANT!
Configuration of the remote cookie should match the configuration of the local cookie on the
device at the other end of the L2TPv3 tunnel.
Type remote-cookie and then configure the following parameters as required:
5.
Parameter
size { size }
low-value { low-value }
high-value { high-value }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 12.4.5.3
Deleting a Session
To delete a session for a static or dynamic L2TPv3 tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the tunnel by typing:
no tunnel l2tpv3 [ static | dynamic ] tunnel tunnel-name session tunnel-session
Where:
• tunnel-name is the name of the tunnel
• tunnel-session is the name of the tunnel session
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Deleting a Session
Lower value of cookie. This value must match with low-value of other endpoint's remote
cookie
Synopsis: A 32-bit unsigned integer
Higher value of cookie if the cookie size is 8. This value must match with high-value of
other endpoint's remote cookie
Synopsis: { 4, 8 }
Cookie size in byte
Synopsis: A 32-bit unsigned integer
Lower value of cookie. This value must match with low-value of other endpoint's local
cookie
Synopsis: A 32-bit unsigned integer
Higher value of cookie if its size is 8. This value must match with high-value of other
endpoint's local cookie
Tunneling and VPNs
Description
Description
Chapter 12
385