Siemens RUGGEDCOM ROX II User Manual page 671

RUGGEDCOM ROX II
CLI User Guide
services
link-failover switch.0001
backup fe-1-1
transfer-default-route
backup-gateway
!
backup te1-2-1c01ppp
priority
transfer-default-route
!
!
!
If no backup interfaces have been configured, add backup interfaces as needed. For more information, refer to
Section 14.2.4.2, "Adding a Link Failover Backup
Section 14.2.4.2
Adding a Link Failover Backup Interface
To set a link failover backup interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the backup interface by typing:
services link-failover interface backup backup-interface
Where:
• interface is the name of the interface
• backup-interface is the name of the secondary, backup interface
3. Configure the following parameter(s) as required:
NOTE
Do not configure the backup-gateway parameter for Point to Point (P2P) links.
NOTE
The on-demand parameter is set at the interface itself.
Parameter
priority { priority }
transfer-default-route
backup-gateway { backup-gateway }
on-demand
Adding a Link Failover Backup Interface
192.168.1.2
second
Interface".
Synopsis: { third, second, first }
Default: first
The priority which is applied to the backup interface when switching.
The transfer default gateway on the switching main and backup interface. The default
route on the device must have a distance greater than one.
Synopsis: A string 1 to 15 characters long
The IP address of the backup gateway.
Synopsis: { true, false }
Displays the status of the interface's On-demand option. When enabled, link failover can
set the interface to up or down as needed. The interface is down until needed by link
failover. When disabled, link failover cannot set the interface to up or down. By default,
the interface is always up.
Network Redundancy
Description
Chapter 14
625