Siemens RUGGEDCOM ROX II User Manual page 68

Chapter 2
Using RUGGEDCOM ROX II
• For Hosts with IPv4 Addresses
ping address iface interface count attempts wait seconds
• For Hosts with IPv6 Addresses
ping6 address iface interface count attempts wait seconds
Where:
• address is the IP address of the host
• attempts is the number of ping attempts
• interface is the interface to use
• seconds is the maximum number of seconds to for a response from the host
Section 2.4.3
Pinging MPLS Endpoints
To ping an MPLS endpoint, type:
mpls-ping address number
Where:
• address is the IPv4 address and prefix of the MPLS endpoint
• number is the number of ping attempts
Section 2.4.4
Pinging VRF Endpoints
To ping an VRF endpoint, type:
vrf-ping address address count attempts vrfname name
Where:
• address is the IPv4 address and prefix of the VRF endpoint
• attempts is the number of ping attempts
• name is the target VRF
Section 2.4.5
Tracing a Route to an IPv4 Host
To trace a route to an IPv4 host, do the following:
traceroute host
Where:
• host is the name or IP address of the remote host
The results of the trace are displayed. For example:
22
RUGGEDCOM ROX II
CLI User Guide
Pinging MPLS Endpoints