Siemens RUGGEDCOM ROX II User Manual page 397

RUGGEDCOM ROX II
CLI User Guide
• local-port is the port number for the local host
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 10.7
Managing Remote Host Interfaces
Remote host interfaces are required when the UDP transport connection protocol is selected for the raw socket
protocol and when the remote host is a multicast stream.
CONTENTS
• Section 10.7.1, "Viewing a List of Remote Host Interfaces"
• Section 10.7.2, "Adding a Remote Host Interface"
• Section 10.7.3, "Deleting a Remote Host Interface"
Section 10.7.1
Viewing a List of Remote Host Interfaces
To view a list of remote host interfaces configured for a serial port using the raw socket protocol, type:
show running-config interface serial slot port protocols rawsocket setrawsocket remote-host remote-host
interface
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• remote-host is the remote host
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface serial lm5 1 protocols rawsocket setrawsocket remote-host
224.1.2.1 interface
interface
serial lm5 1
protocols rawsocket
setrawsocket remote-host 224.1.2.1
interface ge-4-4
!
!
!
!
!
If no remote host interfaces have been configured, add interfaces as needed. For more information, refer to
Section 10.7.2, "Adding a Remote Host
Managing Remote Host Interfaces
Interface".
Chapter 10
Serial Server
351