Siemens RUGGEDCOM ROX II User Manual page 281

RUGGEDCOM ROX II
CLI User Guide
Parameter
authorize-server
option82
4. [Optional] Configure configuration options for DHCP clients at the shared network level. For more
information, refer to refer to
(IPv4)" or Section 7.3.5.2, "Configuring Standard DHCP Client Configuration Options
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 7.3.7.4
Deleting a Shared Network
To delete a shared network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the shared network by typing:
• For IPv4
no services dhcpserver shared-network name
• For IPv6
no services dhcpserver6 shared-network name
Where:
• name is the name of the shared network
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 7.3.8
Managing Subnets
Subnets control settings for each subnet that DHCP serves. A subnet can include a range of IP addresses to give
clients. Subnets contain groups, pools and hosts. Only one subnet can contain dynamic IP address ranges without
any access restrictions on any given physical port, since DHCP doesn't know which subnet a client should belong
to when the request is received.
CONTENTS
• Section 7.3.8.1, "Viewing a List of Subnets"
• Section 7.3.8.2, "Adding a Subnet"
• Section 7.3.8.3, "Configuring Subnet Options"
• Section 7.3.8.4, "Deleting a Subnet"
Deleting a Shared Network
Enables/disables the server's authorization on this client. If enabled, the server will send
deny messages to the client that is trying to renew the lease, which the server knows the
client shouldn't have.
Enables/disables the NAK of option 82 clients for this subnet.
Section 7.3.5.1, "Configuring Standard DHCP Client Configuration Options
IP Address Assignment
Description
(IPv6)".
Chapter 7
235