Siemens RUGGEDCOM ROX II User Manual page 327

RUGGEDCOM ROX II
CLI User Guide
!
!
If no Ethernet trunk interfaces have been configured, add trunks as needed. For more information, refer to
Section 8.2.2, "Adding an Ethernet Trunk
Section 8.2.2
Adding an Ethernet Trunk Interface
To add an Ethernet trunk interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the interface by typing:
interface trunks id
Where:
• id is the ID given to the trunk
3. Configure the interface by typing the following commands:
Parameter
switchport
on-demand
ip-address-src { ip-address-src }
ipv6-address-src { ipv6-address-src }
proxyarp
mtu { mtu }
alias { alias }
4. Configure the multicast filtering settings by typing the following commands:
Parameter
gmrp { gmrp }
Adding an Ethernet Trunk Interface
Interface".
Synopsis: { true, false }
The physical port into either Switched mode or a dedicated Routing mode.
Bring up this interface on-demand only
Synopsis: { static, dynamic }
Whether the IP address is static or dynamically assigned via DHCP or BOOTP. Option
DYNAMIC is a common case of a dynamically assigned IP address. It switches between
BOOTP and DHCP until it gets the response from the relevant server. This must be static
for non-management interfaces.
Synopsis: { static, dynamic }
Default: static
Whether the IP address is static or dynamically assigned via DHCP. Option DYNAMIC
is a common case of a dynamically assigned IP address. This must be static for non-
management interfaces.
Enables/Disables whether the VLAN will respond to ARP requests for hosts other than
itself
Synopsis: A 32-bit signed integer between 68 and 9216
Default: 1500
Maximum transmission unit (largest packet size allowed for this interface).
Synopsis: A string 1 to 64 characters long
The SNMP alias name of the interface
Synopsis: { advertise_only, learn_advertise }
GMRP (GARP Multicast Registration Protocol) operation on the port. There are several
GMRP operation modes:
• DISABLED : the port is not capable of any GMRP processing.
Description
Description
Chapter 8
Layer 2
281