Siemens RUGGEDCOM ROX II User Manual page 186

Chapter 6
Security
IMPORTANT!
Passwords are case-sensitive.
1. Make sure the CLI is in Configuration mode.
2. Type the following:
admin authentication radius
3. [Optional] If port security is enabled on any ports, configuring the following parameter(s) to avoid conflicts
with firewall rules/policies:
Parameter
nas-ip-address { nas-ip-address }
nas-identifier { nas-identifier }
Configure the primary or secondary RADIUS server by typing either primary or secondary and configuring
4.
the following parameter(s) as required:
Parameter
address { address }
port-udp { port-udp }
password { password }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 6.7.3.2
Configuring RADIUS Authentication for PPP Services
To configure RADIUS authentication for PPP services, do the following:
IMPORTANT!
Passwords are case-sensitive.
1. Make sure the CLI is in Configuration mode.
2. Type the following:
global ppp radius
Configure the primary or secondary RADIUS server by typing either primary or secondary and configuring
3.
the following parameter(s) as required:
Parameter
address { address }
140
Synopsis: A string 7 to 15 characters long or a string 6 to 40 characters long
The NAS-IP-Address. Set this to the primary IP address of the unit.
Synopsis: A string 1 to 64 characters long
The NAS-Identifier. If not set, the hostname will be used as the NAS-Identifier.
Synopsis: A string 7 to 15 characters long or a string 6 to 40 characters long
The IP address of the server.
Synopsis: A 32-bit signed integer between 1 and 65535
Default: 1812
The network port of the server.
Synopsis: A string
The password of the RADIUS server.
Synopsis: A string 7 to 15 characters long
Description
Description
Description
Configuring RADIUS Authentication for PPP Services
RUGGEDCOM ROX II
CLI User Guide