Siemens RUGGEDCOM ROX II User Manual page 707

RUGGEDCOM ROX II
CLI User Guide
show interfaces switch rna nodesTable
A table similar to the following appears:
ruggedcom# show interfaces switch rna nodesTable
LRE
INTERFACE
STATS LRE NODES
INDEX INDEX
-----------------------------------------------------------------------
129 3003009056
This table displays the following information about each node:
Parameter
lreInterfaceStatsIndex
lreNodesIndex
lreNodesMacAddress
lreTimeLastSeenA
lreTimeLastSeenB
lreRemNodeType
Section 14.4.5
Viewing Statistics Collected for RNA Ports
The device collects statistics on traffic traversing the RNA ports.
NOTE
Statistics displayed are not updated automatically.
Redundant Network Access Port Statistics
Type the following command to view the the number of nodes the RedBox is aware of on the redundancy and
non-redundancy sides of the network. It also displays the MAC address being broadcast in supervision frames.
show interfaces switch slot port rna
Where:
• slot is the slot where the chosen PRP module resides
• port is the chosen port on the PRP module
Viewing Statistics Collected for RNA Ports
LRE TIME
LRE NODES MAC LAST
ADDRESS SEEN A
00:0a:dc:af:e4:e0 42394000
Synopsis: A 32-bit unsigned integer
A unique value for each LRE.
Synopsis: A 32-bit unsigned integer
Unique value for each node in the LRE's node table.
Synopsis: A string
Each MAC address corresponds to a single Dual Attached Node
Synopsis: A string
Time in TimeTicks (1/100s) since the last frame from this remote LRE was received over LAN
A. Initialized with a value of 0 upon node registration in the node table.
Synopsis: A string
Time in TimeTicks (1/100s) since the last frame from this remote LRE was received over LAN
B. Initialized with a value of 0 upon node registration in the node table.
Synopsis:
DAN type, as indicated in the received supervision frame
LRE TIME LRE REM
LAST NODE
SEEN B TYPE
42183000 redboxp
Description
Chapter 14
Network Redundancy
661