Siemens RUGGEDCOM ROX II User Manual page 393

RUGGEDCOM ROX II
CLI User Guide
loopback true
For more information, refer to
13. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
14. Verify the configuration by typing the following:
traceserial
Final Configuration Example
Serial Port 1 Configuration
serial lm1 1
no alias
protocols rawsocket
setrawsocket local-port 10001
setrawsocket transport udp
setrawsocket remote-host 232.1.1.1 5001
loopback true
interface switch.0010
!
interface switch.0020
Serial Port 2 Configuration
serial lm1 2
no alias
protocols rawsocket
setrawsocket local-port 5001
setrawsocket transport udp
setrawsocket local-host 232.1.1.1
loopback true
Section 10.5
Managing Remote Hosts
Remote hosts are required when the UDP transport connection protocol is selected for the raw socket protocol.
CONTENTS
• Section 10.5.1, "Viewing a List of Remote Hosts"
• Section 10.5.2, "Adding a Remote Host"
• Section 10.5.3, "Deleting a Remote Host"
Section 10.5.1
Viewing a List of Remote Hosts
To view a list of remote hosts configured for a serial port using the raw socket protocol, type:
show running-config interface serial protocols rawsocket setrawsocket remote-host
If hosts have been configured, a table or list similar to the following example appears:
Managing Remote Hosts
Section 10.6.2, "Adding a Local Host"
Chapter 10
Serial Server
347