Siemens RUGGEDCOM ROX II User Manual page 479

RUGGEDCOM ROX II
CLI User Guide
Section 12.10.3.3
Deleting a DMVPN Interface
To delete a DMVPN interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address pool by typing:
no services nhrp interface-nhrp gre-tunnel
Where gre-tunnel is the name of the desired GRE tunnel.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.10.4
Viewing the Status of DMVPN
To view the status of the DMVPN service, type:
show services nhrp status
If DMVPN interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show services nhrp status
ROW RAW FROM OPENNHRPCTL
---------------------------------------
0
1 Status: ok
2
3 Interface: gre-gre-1
4 Type: local
5 Protocol-Address: 192.168.0.1/32
6 Flags: up
7
8 Status: ok
9
10 Interface: gre-gre-1
11 Type: static
12 Protocol-Address: 192.168.0.2/24
13 NBMA-Address: 61.1.1.2
14 Flags: up
15
16 Status: ok
17
18 Interface: gre-gre-2
19 Type: local
20 Protocol-Address: 192.168.1.1/32
21 Flags: up
22
23 Status: ok
24
25 Interface: gre-gre-2
26 Type: static
27 Protocol-Address: 192.168.1.2/24
28 NBMA-Address: 71.1.1.2
29 Flags: up
30
Information provided is taken directly from NHRP. The following are some of the fields that may be displayed:
Deleting a DMVPN Interface
Chapter 12
Tunneling and VPNs
433