Siemens RUGGEDCOM ROX II User Manual page 110

Chapter 4
Device Management
Section 4.6
Restoring Factory Defaults
To restore the factory defaults for the device, use the following command:
admin restore-factory-defaults
If necessary, include the following options:
Parameter
delete-logs
default-both-partitions
delete-saved-configurations
shutdown
Section 4.7
Decommissioning the Device
Before taking the device out of service, either permanently or for maintenance by a third-party, make sure the
device has been fully decommissioned. This includes removing any sensitive, proprietary information.
To decommission the device, do the following:
1. Obtain a copy of the RUGGEDCOM ROX II firmware currently installed on the device. For more information,
contact Siemens Customer Support.
2. Log in to maintenance mode. For more information, refer to
3. Delete the current boot password/passphrase by typing:
rox-delete-bootpwd --force
Type exit and press Enter.
4.
5. Log in to RUGGEDCOM ROX II. For more information, refer to
6. Flash the RUGGEDCOM ROX II firmware obtained in
more information, refer to
7. Repeat Step 5 and
and reboot the device.
8. Shut down the device. For more information, refer to
64
Synopsis: { true, false }
Default: false
Delete system logs as well as restoring default settings.
Synopsis: { true, false }
Default: false
Perform the operation on both partitions.
Synopsis: { true, false }
Default: false
Delete saved configuration files (works with default-both-partitions option).
Synopsis: { true, false }
Default: false
Shutdown rather than reboot after restoring factory defaults.
Section 4.12.5.2, "Downgrading Using
Step 6 to flash the RUGGEDCOM ROX II firmware obtained in
Description
Section 2.7.3, "Accessing Maintenance
Section 2.2, "Logging
Step 1 to the inactive partition and reboot the device. For
ROXflash".
Section 4.4, "Shutting Down the
RUGGEDCOM ROX II
CLI User Guide
Mode".
In".
Step 1 to the other partition
Device".
Restoring Factory Defaults