Siemens RUGGEDCOM ROX II User Manual page 593

RUGGEDCOM ROX II
CLI User Guide
If no static label binding has been configured, configure binding as needed. For more information about
configuring static-binding, refer to
Section 13.10.5.2
Viewing a List of Static Labels
To view a list of static labels, type:
show running-config mpls static-mpls binding [ ipv4 | ipv6 ]
If static labels have been configured, a list similar to the following example appears:
ruggedcom# show running-config mpls static-mpls binding ipv4
mpls
static-mpls
binding
ipv4
dest-address 192.168.52.52/32
next-hop 192.168.10.2
out-label 16
!
!
!
!
!
If no static labels have been configured, add labels as needed. For more information about adding static labels,
refer to Section 13.10.5.3, "Adding a Static
Section 13.10.5.3
Adding a Static Label
To add a static label, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add a static label by typing:
mpls static-mpls binding [ ipv4 | ipv6 ] dest-address address
Where:
• address is the destination address and prefix.
3. Configure the following parameter(s) as required:
Parameter
in-label { in-label }
next-hop { next-hop }
out-label { out-label }
Viewing a List of Static Labels
Section 13.10.5.3, "Adding a Static
Label".
Synopsis: A 32-bit unsigned integer between 16 and 1048575
The incoming label: integer 16 -> 1048575.
Synopsis: A string 7 to 15 characters long
The IP address for the destination next-hop router.
Synopsis: { explicit-null, implicit-null } or a 32-bit unsigned integer between 16 and
1048575
The outgoing label:
• implicit null - The label has a value of 3, meaning the penultimate (next-to-last) router
performs a pop operation and forwards the remainder of the packet to the egress
Unicast and Multicast Routing
Label".
Description
Chapter 13
547