Siemens RUGGEDCOM ROX II User Manual page 627

RUGGEDCOM ROX II
CLI User Guide
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.12
Managing Static Routing
Static routes can be manually added to the routing table when there are no notifications sent by other routers
regarding network topology changes.
CONTENTS
• Section 13.12.1, "Viewing a List of Static Routes"
• Section 13.12.2, "Adding an IPv4 Static Route"
• Section 13.12.3, "Adding an IPv6 Static Route"
• Section 13.12.4, "Deleting a Static Route"
• Section 13.12.5, "Configuring a Black Hole Connection for an IPv4 Static Route"
• Section 13.12.6, "Managing Gateways for Static Routes"
• Section 13.12.7, "Managing Interfaces for Static Routes"
Section 13.12.1
Viewing a List of Static Routes
To view a list of routable Ethernet ports, type:
show running-config routing protocol
Where:
• protocol is either IPv4 or IPv6
If routes have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ipv4 | tab
NETWORK DISTANCE
-------------------------------------------------------------------------------------
0.0.0.0/0 -
10.200.16.0/20 -
If no static routes have been configured, add routes as needed. For more information, refer to
"Adding an IPv4 Static Route"
Managing Static Routing
HW
ACCELERATE GW
-
172.30.128.1
-
or Section 13.12.3, "Adding an IPv6 Static
DISTANCE INTERFACE
-
switch.0001
Route".
Unicast and Multicast Routing
DISTANCE
-
Section 13.12.2,
Chapter 13
581