Siemens RUGGEDCOM ROX II User Manual page 144

Chapter 4
Device Management
Loss of Signal implemented, inverted (often called Signal Detect)
BRmax: 700 Mbps
BRmin: Not specified
Serial number:
Manufacturing date code: Y:AV M:AG D:O
Monitoring type: Digital diag monitoring - MUST be '1' but is '0'
Internally calibrated
Received power measurement type - OMA
Enhanced options: Soft TX_FAULT monitoring
SFF-8472 revision compliance: Unknown 20
Section 4.17.3
Enabling/Disabling Smart SFP Mode (RUGGEDCOM RX5000
Only)
Smart SFP mode can be disabled for SFP transceivers that do not support Smart SFP. These transceivers are
disabled automatically upon insertion and marked as Unidentified.
NOTE
Smart SFP mode is only available for any port on the RUGGEDCOM RX1500PN LM 4FG50 line module.
NOTE
The parameter will display the following if the SFP transceiver is marked as Unidentified:
SFP - Unidentified
The SFP transceiver is not marked as Unidentified, the media displays information about the SFP
transceiver. For example:
SFP 1000LX SM LC 10 km
NOTE
If an SFP transceiver remains marked as Unidentified after disabling Smart SFP mode, contact Siemens
Customer Support.
To enable or disable Smart SFP mode for an SFP transceiver, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable Smart SFP mode by typing:
Enable
interface switch slot port sfp smart-sfp-mode
Disable
no interface switch lmslot port sfp smart-sfp-mode
3. If Smart SFP mode is disabled, review the configuration for the SFP transceiver socket. Some settings may
need to be adjusted manually to match the capabilities of the installed SFP transceiver. For more information,
refer to Section 8.1.2, "Configuring a Switched Ethernet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
98
Port".
Enabling/Disabling Smart SFP Mode (RUGGEDCOM RX5000
RUGGEDCOM ROX II
CLI User Guide
Only)