Siemens RUGGEDCOM ROX II User Manual page 668

Chapter 14
Network Redundancy
show services link-failover status
A table or list similar to the following appears:
ruggedcom# show services link-failover status
MAIN
LINK
MAIN STATUS
---------------------------------------------------------------------------------------------
switch.0001 up
The table or list provides the following information:
Parameter
main-link-status
backup-link-status
main-ping-test
time-of-last-state-change
link-backup-state
backup-interface-in-use
Section 14.2.3
Managing Link Failover Parameters
This section describes how to manage parameter settings for link failover.
CONTENTS
• Section 14.2.3.1, "Viewing a List of Link Failover Parameters"
• Section 14.2.3.2, "Adding a Link Failover Parameter"
• Section 14.2.3.3, "Deleting a Link Failover Parameter"
Section 14.2.3.1
Viewing a List of Link Failover Parameters
To view a list of link failover parameters, type:
show running-config services link-failover
If parameters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services link-failover
services
622
BACKUP MAIN
LINK PING TIME OF LAST STATE
STATUS TEST CHANGE
down ok Fri Jan 25 09:49:52 2013
Synopsis: A string
The main link status.
Synopsis: A string
The backup link status.
Synopsis: A string
The results of pinging the target using the main interface.
Synopsis: A string
The time of the last state change.
Synopsis: A string
The backup link state.
Synopsis: A string
The name of the backup interface that is being used.
LINK BACKUP STATE
Main path is active fe-1-1
Description
Managing Link Failover Parameters
RUGGEDCOM ROX II
CLI User Guide
BACKUP
INTERFACE
IN USE