Siemens RUGGEDCOM ROX II User Manual page 618

Chapter 13
Unicast and Multicast Routing
If no redistributions have been configured, add them as needed. For more information, refer to
Section 13.11.11.2, "Adding a
Section 13.11.11.2
Adding a Redistribution
To add a redistribution for an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the redistribution by typing:
routing bgp address-family ipv4 vrf vrf redistribute [ connected | ospf | static ]
Where:
• vrf is the chosen VRF instance
3. Configure the following parameter(s) as required:
Parameter
metric { metric }
route-map { route-map }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.11.11.3
Deleting a Redistribution
To delete a redistribution defined for an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the redistribution by typing:
no routing bgp address-family ipv4 vrf vrf redistribute [ connected | ospf | static ]
Where:
• vrf is the chosen VRF instance
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.11.12
Managing Neighbors for IPv4 Address Families
Neighbors are other routers with which to exchange routes. One or more neighbors must be specified in order for
VRF to operate.
CONTENTS
• Section 13.11.12.1, "Viewing a List of Neighbors"
572
Redistribution".
Synopsis: A 32-bit unsigned integer between 0 and 4294967295
The metric for redistributed routes.
Synopsis: A string
The route map name.
Description
Adding a Redistribution
RUGGEDCOM ROX II
CLI User Guide