Table of Contents
Advertisement
Chapter 10
Serial Server
Configure ser-1-1 and ser-1-2
1.
Configure IP addresses for the interfaces (switch.0010 and switch.0020). For more information, refer to
Section 7.1.3.2, "Adding an IPv4
2.
Create a raw socket connection for ser-1-1:
interface serial lm1 1 protocols rawsocket
For more information, refer to
3.
Set the raw socket of the local port to 10001:
setrawsocket local-port 10001
For more information, refer to
4.
Set the transport method to UDP:
setrawsocket transport udp
For more information, refer to
5.
Set the multicast group for the remote host to 232.1.1.1 and the UDP destination port to 5001:
setrawsocket remote-host 232.1.1.1 5001
For more information, refer to
6.
Set switch.0010 and switch.0020 as the interfaces for the remote host:
interface switch.0010
interface switch.0020
For more information, refer to
7.
Enable remote host loopback:
loopback true
For more information, refer to
8.
Create a raw socket connection for ser-1-2:
interface serial lm1 2 protocols rawsocket
For more information, refer to
9.
Set the raw socket of the local port to 5001. This must be the same as the UDP destination port of the
multicast remote host configured for ser-1-1:
setrawsocket local-port 5001
For more information, refer to
10. Set the transport method to UDP:
setrawsocket transport udp
For more information, refer to
11. Set the multicast group for the local host to 232.1.1.1. This must be the same as the destination multicast
group configured for the multicast remote host configured for ser-1-1.
setrawsocket local-host 232.1.1.1
For more information, refer to
12. Enable local host loopback:
346
Address".
Section 10.2.3, "Adding a Serial Port
Section 10.2.6, "Configuring the Raw Socket
Section 10.2.6, "Configuring the Raw Socket
Section 10.5.2, "Adding a Remote
Section 10.7.2, "Adding a Remote Host Interface"
Section 10.6.2, "Adding a Local Host"
Section 10.2.3, "Adding a Serial Port Protocol"
Section 10.6.2, "Adding a Local Host"
Section 10.2.6, "Configuring the Raw Socket
Section 10.6.2, "Adding a Local Host"
Protocol".
Protocol".
Protocol".
Host".
Protocol".
Example: Serial Interfaces Configured as a Source and Sink
RUGGEDCOM ROX II
CLI User Guide
for Multicast Streams
Hide quick links:
Advertisement
Chapters
Table of Contents
