Siemens RUGGEDCOM ROX II User Manual page 316

Chapter 8
Layer 2
Parameter
ipv6-address-src { ipv6-address-src }
proxyarp
mtu { mtu }
alias { alias }
4. Configuring the rate Limiting settings by configuring the following parameter(s) as required:
Parameter
ingress-limit { ingress-limit }
ingress-frames { ingress-frames }
egress-limit { egress-limit }
5. Configure the LLDP settings by configuring the following parameter(s) as required:
Parameter
admin-status { admin-status }
notify
270
Synopsis: { static, dynamic }
Default: static
Whether the IPv6 address is static or dynamically assigned via DHCPv6. Option DYNAMIC
is a common case of a dynamically assigned IPv6 address. This must be static for non-
management interfaces.
Enables/Disables whether the VLAN will respond to ARP requests for hosts other than
itself
Synopsis: A 32-bit signed integer between 68 and 9216
Default: 1500
Maximum transmission unit (largest packet size allowed for this interface).
Synopsis: A string 1 to 64 characters long
The SNMP alias name of the interface
Synopsis: { disabled } or a 32-bit signed integer between 62 and 256000
Default: 1000
The data rate in kbps at which received frames (of the type described by the ingress
frames parameter) will start to be discarded by the switch. The valid range is 62 to
256000 kbps. The default value is 1000 kbps. If not set(cleared), this feature is disabled.
Synopsis: { broadcast, multicast, mcast-flood-ucast, all }
Default: broadcast
This parameter specifies the types of frames to rate-limit on this port. It applies only to
received frames:
• BROADCAST : only broadcast frames will be limited.
• MULTICAST : all multicast frames (including broadcast) will be limited.
• MCAST-FLOOD-UCAST : all multicast frames (including broadcast) will be limited.
Unicast will not be limited.
• ALL : all frames (both multicast and unicast) will be limited.
Synopsis: { disabled } or a 32-bit signed integer between 62 and 256000
Default: disabled
The maximum data rate in kbps at which the switch will transmit (multicast, broadcast
and unicast) frames on this port. The switch will discard frames in order to meet this rate
if required. The valid range is 62 to 256000 Kbps. If not set, this feature is disabled.
Synopsis: { tx-only, rx-only, rx-tx, no-lldp }
Default: rx-tx
• no-lldp : The local LLDP agent can neither transmit nor receive LLDP frames.
• rxTx : The local LLDP agent can both transmit and receive LLDP frames through the
port.
• txOnly : The local LLDP agent can only transmit LLDP frames.
• rxOnly : The local LLDP agent can only receive LLDP frames.
Disabling notifications will prevent sending notifications and generating alarms for a
particular interface from the LLDP agent.
Description
Description
Description
Configuring a Switched Ethernet Port
RUGGEDCOM ROX II
CLI User Guide