Siemens RUGGEDCOM ROX II User Manual page 87

RUGGEDCOM ROX II
CLI User Guide
Parameter
Section 2.5.10.5
Configuration Mode General Commands
Configuration mode provides a set of general commands that allow users to work with configuration data.
Parameter
abort
clear
commit no-confirm
commit abort
commit and-quit
commit check
commit confirmed timeout
commit comment text
commit label text
commit persist-id text
commit save-running file
Configuration Mode General Commands
the device will continue to be blocked from making changes until the session
timeout period expires.
Exits the configuration session without saving changes.
NOTE
In an edit exclusive session, any pending unconfirmed commits will not be
canceled until their timeout periods expire. A new edit exclusive session cannot
be opened until the timeout period ends.
Deletes all configuration changes.
Immediately commits the current set of configuration changes. This command will prompt
the user to confirm the action. Use the no-confirm parameter to revert the configuration
without requiring confirmation.
In an edit exclusive session, this command aborts/cancels all confirmed commits.
Commits all confirmed and unconfirmed changes and exits the configuration mode.
Validates the current configuration.
Temporarily commits changes for a period of time, allowing users to test the configuration
before fully committing the changes. The changes must be committed using a standard
commit command before the timeout period ends. If changes are not committed before the
timeout period ends, they are automatically discarded and the previous settings are restored.
A timeout period can be specified at the end of the command. The default timeout period is
10 minutes. The minimum timeout period is 1 minute. For example:
ruggedcom(config-admin)# commit confirmed 2
To cancel a commit before the time elapses and discard the changes, type:
commit abort
To permanently commit the changes before the time elapses, type:
commit
Immediately commits the current set of configuration changes along with a custom
comment. The comment will appear next to the commit in a list of pending of commits.
Immediately commits the current set of configuration changes along with a custom label. In
a list of pending commits, the label will appear instead of the auto-generated commit ID.
Immediately commits the current set of configuration changes and assigns a user-specified
ID or flag.
Immediately commits the current set of configuration changes and saves them to the
specified file. It does not save the complete running configuration.
Using RUGGEDCOM ROX II
Description
Description
Chapter 2
41