Siemens RUGGEDCOM ROX II User Manual page 512

Chapter 13
Unicast and Multicast Routing
routing rip filter prefix-list name entry number
Where:
• name is the name of the prefix list
• number is the sequence number for the entry
3. Configure the following parameter(s) as required:
Parameter
action { action }
subnet { subnet }
le { le }
ge { ge }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.7.3.5
Deleting a Prefix List
To delete a prefix list for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
NOTE
Deleting a prefix list removes all associate prefix entries as well.
2. Delete the list by typing:
no routing rip filter prefix-list name
Where:
• name is the name of the prefix list
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.7.3.6
Deleting a Prefix Entry
To delete an entry for a dynamic RIP prefix list, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the entry by typing:
466
Synopsis: { deny, permit }
Default: permit
The action that will be performed.
Synopsis: A string 9 to 18 characters long
The IPv4 network address and prefix.
This parameter is mandatory.
Synopsis: An 8-bit unsigned integer between 1 and 32
The maximum prefix length to be matched.
Synopsis: An 8-bit unsigned integer between 1 and 32
The minimum prefix length to be matched.
Description
Deleting a Prefix List
RUGGEDCOM ROX II
CLI User Guide