Siemens RUGGEDCOM ROX II User Manual page 662

Chapter 14
Network Redundancy
2. Add the instance by typing:
services vrrp instance name vrip address
Where:
• name is the name of the VRRP instance
• address is the address and subnet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 14.1.9.3
Deleting a Virtual IP Address
To delete a virtual IP address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the virtual IP address by typing:
no services vrrp instance name vrip address
Where:
• name is the name of the VRRP instance
• address is the virtual IP address and netmask
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 14.1.10
Managing Connection Synchronization
This section describes how to configure connection synchronization between two VRRP-enabled routers.
CONTENTS
• Section 14.1.10.1, "Configuring Connection Synchronization"
• Section 14.1.10.2, "Enabling/Disabling Connection Synchronization"
• Section 14.1.10.3, "Viewing a List of Dedicated LInks"
• Section 14.1.10.4, "Adding a Dedicated Link"
• Section 14.1.10.5, "Deleting a Dedicated Link"
• Section 14.1.10.6, "Selecting a Default Dedicated Link"
• Section 14.1.10.7, "Viewing the Status of Each Dedicated Link"
Section 14.1.10.1
Configuring Connection Synchronization
To configure connection synchronization, do the following for each VRRP-enabled device:
616
RUGGEDCOM ROX II
CLI User Guide
Deleting a Virtual IP Address