Siemens RUGGEDCOM ROX II User Manual page 171

RUGGEDCOM ROX II
CLI User Guide
Security
This chapter describes how to configure and manage the security-related features of RUGGEDCOM ROX II.
CONTENTS
• Section 6.1, "Enabling and Configuring CLI Sessions"
• Section 6.2, "Enabling and Configuring SFTP Sessions"
• Section 6.3, "Enabling/Disabling Brute Force Attack Protection"
• Section 6.4, "Enabling/Disabling Compact Flash Card Removal Detection"
• Section 6.5, "Enabling/Disabling SYN Cookies"
• Section 6.6, "Managing Port Security"
• Section 6.7, "Managing User Authentication"
• Section 6.8, "Managing Certificates and Keys"
• Section 6.9, "Managing Firewalls"
Section 6.1
Enabling and Configuring CLI Sessions
To enable and configure CLI sessions, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to admin » cli and configure the following parameter(s) as required:
Parameter
enabled
listen-ip { listen-ip }
port { port }
extra-ip-ports { extra-ip-ports }
Enabling and Configuring CLI Sessions
Synopsis: { true, false }
Default: true
When enabled, a command line interface (CLI) may be used to configure the device. A
secure shell (SSH) client or serial console may be used to access the CLI.
Synopsis: A string
Default: 0.0.0.0
The IPv4 or IPv6 address on which the CLI will listen for requests from the device. The
default value (i.e. 0.0.0.0) enables the CLI to receive requests via any IP address with
which it is associated.
Synopsis: A 16-bit unsigned integer between 0 and 65535
Default: 22
The default port on which the CLI will listen for requests from the device. The port
corresponds with the IP address specified by the Listen IP (listen-ip) parameter.
Synopsis: A string
Description
Chapter 6
Security
125