Siemens RUGGEDCOM ROX II User Manual page 278

Chapter 7
IP Address Assignment
!
!
If no DHCP listen interfaces have been configured, add interfaces as needed. For more information, refer to
Section 7.3.6.2, "Adding a DHCP Listen
Section 7.3.6.2
Adding a DHCP Listen Interface
To add a DHCP listen interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the interface by typing:
• For IPv4
services dhcpserver interface name
• For IPv6
services dhcpserver6 interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 7.3.6.3
Deleting a DHCP Listen Interface
To delete a DHCP listen interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
• For IPv4
no services dhcpserver interface name
• For IPv6
no services dhcpserver6 interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 7.3.7
Managing Shared Networks
Shared networks are used when multiple subnets should be served by a single physical port. This applies both
when using a DHCP relay agent connected to the port with additional subnets behind the relay agent, or when
232
Interface".
RUGGEDCOM ROX II
CLI User Guide
Adding a DHCP Listen Interface