Siemens RUGGEDCOM ROX II User Manual page 160

Chapter 5
System Administration
logout [ [ session | number ] [ user | profile ] ]
Where:
• number is the session number
• profile is the name of the user profile
Section 5.8.4.2
Sending Messages to Users
To broadcast a message to all users or a specific user, type:
send [ profile | all ] message
Where:
• profile is the name of the user profile
• message is the message
Section 5.9
Managing Passwords and Passphrases
RUGGEDCOM ROX II requires separate passwords or passphrases for logging into the various device modes, such
as normal, boot, service and maintenance modes. Default passwords are configured for each user type initially. It
is strongly recommended that these be changed before the device is commissioned.
NOTE
For a list of default passwords, refer to
The complexity of each password/passphrase can be chosen by the user or enforced through the device by an
administrator. If a user's password/passphrase does not meet the password requirements, an alarm is generated.
For example:
Error: Supplied password is shorter than the minimum password length: 12
In general, passwords/passphrases should consist of:
• One lower case character
• One upper case character
• One number
• One special character (i.e. !@#$%^&*()_+-={}[];:',<.>/?\|`~)
NOTE
User authentication can also be verified through a RADIUS or TACACS+ server. When enabled
for authentication and authorization, the RADIUS or TACACS+ server will be used. For more
information about configuring a RADIUS or TACACS+ server, refer to
Authentication"
114
Section 2.1, "Default User Names and
and Section 6.7.4, "Configuring TACACS+
Passwords".
Section 6.7.3, "Managing RADIUS
Authentication".
Sending Messages to Users
RUGGEDCOM ROX II
CLI User Guide