Siemens RUGGEDCOM ROX II User Manual page 535

RUGGEDCOM ROX II
CLI User Guide
If no prefix lists have been configured, add lists as needed. For more information, refer to
"Adding a Prefix List".
Section 13.8.4.2
Viewing a List of Prefix Entries
To view a list of entries for dynamic BGP, OSPF, or BGP prefix lists, type:
routing bgp filter prefix-list name entry
Where:
• name is the name of the prefix list
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter prefix-list test entry | tab
SEQ ACTION SUBNET
---------------------------------------------
5 permit 192.168.40.0/24
6 deny 192.168.5.21/32
!
!
If no entries have been configured, add entries as needed. For more information, refer to
"Adding a Prefix Entry".
Section 13.8.4.3
Adding a Prefix List
To add a prefix list for dynamic BGP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the list by typing:
routing bgp filter prefix-list name
Where:
• name is the name of the prefix list
3. Configure the following parameter(s) as required:
Parameter
description { description }
4. Add prefix entries as needed. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Viewing a List of Prefix Entries
LE GE
32 -
- -
Synopsis: A string 1 to 1024 characters long
The description of the prefix list.
Unicast and Multicast Routing
Description
Section 13.8.4.4, "Adding a Prefix
Chapter 13
Section 13.8.4.3,
Section 13.8.4.4,
Entry".
489