Siemens RUGGEDCOM ROX II User Manual page 508

Chapter 13
Unicast and Multicast Routing
Section 13.7.1
Configuring RIP
To configure dynamic routing using the Routing Information Protocol (RIP) daemon, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to routing » rip and configure the following parameter(s) as required:
Parameter
enabled
default-information-originate
default-metric { default-metric }
distance-default { distance-default }
version { version }
3. Configure prefix lists. For more information, refer to
4. Configure a network. For more information, refer to
5. Configure the prefix list distribution. For more information, refer to
Distribution Path".
6. Configure key chains. For more information, refer to
7. Configure redistribution metrics. For more information, refer to
Metric".
8. Configure interfaces. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
9.
Section 13.7.2
Viewing the Status of Dynamic RIP Routes
To view the status of the dynamic RIP routes configured on the device, type:
show routing status rip route
If RIP routes have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status rip route | tab
NETWORK
--------------------------------------------------------------------------------
192.168.0.0/24
192.168.5.0/24
192.168.6.0/24
462
Enables the RIP dynamic routing protocol.
The route element makes a static route only inside RIP. This element should be used
only by advanced users who are particularly knowledgeable about the RIP protocol. In
most cases, we recommend creating a static route and redistributing it in RIP using the
redistribute element with static type.
Synopsis: An 8-bit signed integer between 1 and 16
Default: 1
Sets the default metric. With the exception of connected route types, the default metric
is advertised when a metric has not been configured for a redistributed route. For
connected route types, the default metric is 1 despite the value of this parameter.
Synopsis: A 32-bit unsigned integer between 1 and 255
Sets the default RIP distance.
Synopsis: An 8-bit signed integer between 1 and 2
Set the RIP version to accept for reads and send. The version can be either 1 or 2.
Disabling RIPv1 by specifying version 2 is STRONGLY encouraged.
TYPE SUB TYPE
connected interface
rip normal
rip normal
Section 13.7.3.3, "Adding a Prefix
Section 13.7.4.1, "Configuring a
Section 13.7.9.3, "Adding a Key
Section 13.7.11.2, "Configuring a Routing
NEXT HOP METRIC FROM
0.0.0.0 1 self
192.168.0.3 2 192.168.0.3
192.168.0.3 2 192.168.0.3
Description
List".
Network".
Section 13.7.8.2, "Adding a Prefix List
Chain".
Section 13.7.10.2, "Adding a Redistribution
TAG TI
0
0 02
0 02
RUGGEDCOM ROX II
CLI User Guide
Interface".
Configuring RIP