Siemens RUGGEDCOM ROX II User Manual page 546

Chapter 13
Unicast and Multicast Routing
3. If necessary, configure options for the address. For more information, refer to
Aggregate Address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.8.8.3
Deleting an Aggregate Address
To delete an aggregate address for dynamic BGP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address by typing:
no routing bgp aggregate-address address
Where:
• address is the subnet address and prefix for the aggregate address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.8.9
Managing Aggregate Address Options
This section describes how to set the as-set and summary-only options for BGP aggregate addresses.
CONTENTS
• Section 13.8.9.1, "Viewing a List of Aggregate Address Options"
• Section 13.8.9.2, "Adding an Aggregate Address Option"
• Section 13.8.9.3, "Deleting an Aggregate Address Option"
Section 13.8.9.1
Viewing a List of Aggregate Address Options
To view a list of options for an aggregate address, type:
routing bgp aggregate-address address options
If options have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp aggregate-address 11.11.0.0/16 options
routing bgp
aggregate-address 11.11.0.0/16
options summary-only
!
!
!
If no options have been configured, add options as needed. For more information, refer to
"Adding an Aggregate Address
500
Option".
Option".
RUGGEDCOM ROX II
CLI User Guide
Section 13.8.9.2, "Adding an
Section 13.8.9.2,
Deleting an Aggregate Address