Siemens RUGGEDCOM ROX II User Manual page 537

RUGGEDCOM ROX II
CLI User Guide
Section 13.8.4.6
Deleting a Prefix Entry
To delete an entry for a dynamic BGP prefix list, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the entry by typing:
no routing bgp filter prefix-list name entry number
Where:
• name is the name of the prefix list
• number is the sequence number for the entry
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.8.5
Managing Autonomous System Paths and Entries
This section describes how to configure autonomous system paths and entries for dynamic BGP routes.
CONTENTS
• Section 13.8.5.1, "Viewing a List of Autonomous System Paths"
• Section 13.8.5.2, "Viewing a List of Autonomous System Path Entries"
• Section 13.8.5.3, "Adding an Autonomous System Path Filter"
• Section 13.8.5.4, "Adding an Autonomous System Path Filter Entry"
• Section 13.8.5.5, "Deleting an Autonomous System Path"
• Section 13.8.5.6, "Deleting an Autonomous System Path Filter Entry"
Section 13.8.5.1
Viewing a List of Autonomous System Paths
To view a list of autonomous system path filters for dynamic BGP routes, type:
show running-config routing bgp filter as-path
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter as-path | tab
NAME
---------------------------------
filter-allow-120
!
If no filters have been configured, add filters as needed. For more information, refer to
an Autonomous System Path
Deleting a Prefix Entry
ACTION MATCH
permit 120
Filter".
Chapter 13
Unicast and Multicast Routing
Section 13.8.5.3, "Adding
491