Siemens RUGGEDCOM ROX II User Manual page 611

RUGGEDCOM ROX II
CLI User Guide
If no VRF definitions have been configured, add definitions as needed. For more information, refer to
Section 13.11.5.2, "Adding a VRF
Section 13.11.7.2
Adding a VRF Instance and Configuring OSPF
To add a VRF instance and configure OSPF, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to routing » dynamic » ospf » vrf and configure the following parameter(s) as required:
2.
Parameter
{ vrf-name }
enabled
abr-type { abr-type }
auto-cost-reference-bandwidth { auto-cost-
reference-bandwidth }
compatible-rfc1583
default-information-originate
default-metric { default-metric }
distance { distance }
opaque-lsa
passive-default
refresh-timer { refresh-timer }
router-id { router-id }
always
metric { metric }
metric-type { metric-type }
Adding a VRF Instance and Configuring OSPF
Definition".
Synopsis: A string
The VRF name.
Enables the OSPF dynamic routing protocol.
Synopsis: { cisco, ibm, shortcut, standard }
Default: cisco
The OSPF ABR type.
Synopsis: A 32-bit unsigned integer between 1 and 4294967
Default: 100
Calculates the OSPF interface cost according to bandwidth [1-4294967 Mbps]
Enables the compatibility with the obsolete RFC1583 OSPF (the current is RFC2178)
Advertises the default route.
Synopsis: A 32-bit unsigned integer between 0 and 16777214
The default metric of redistribute routes.
Synopsis: A 32-bit unsigned integer between 1 and 255
The administrative distance.
Enables the Opaque-LSA capability (RFC2370).
Synopsis: { true, false }
Default: true
Default passive value for new interface.
Synopsis: A 16-bit unsigned integer between 10 and 1800
Default: 10
The refresh timer.
Synopsis: A string 7 to 15 characters long
The Router ID for OSPF.
Synopsis: { true, false }
Default: false
Always advertise default route even when there is no default route present in routing
table.
Synopsis: A 32-bit unsigned integer between 0 and 16777214
The metric value for default route.
Synopsis: An 8-bit signed integer between 1 and 2
Default: 2
Unicast and Multicast Routing
Description
Chapter 13
565