Siemens RUGGEDCOM ROX II User Manual page 745

RUGGEDCOM ROX II
CLI User Guide
Parameter
maxbw-unit { maxbw-unit }
priority { priority }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 16.2.4.3
Deleting a Traffic Control Class
To delete a traffic control class, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control class by typing:
no qos traffic-control advanced-configuration tcclasses name
Where:
• name is the name of the traffic control class entry
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 16.2.5
Managing Traffic Control Devices
Traffic control devices define devices used for traffic shaping.
NOTE
Traffic control devices can only be configured in advanced mode. For more information about setting
the traffic control mode, refer to
CONTENTS
• Section 16.2.5.1, "Viewing a List of Traffic Control Devices"
• Section 16.2.5.2, "Adding a Traffic Control Device"
• Section 16.2.5.3, "Deleting a Traffic Control Device"
Deleting a Traffic Control Class
Synopsis: { none, kilobits, megabits }
Default: none
(per second) only if max-bandwidth is a single numerical value
Synopsis: A 16-bit unsigned integer between 0 and 7
Default: 0
The priority in which classes will be serviced. Higher priority classes will experience less
delay since they are serviced first. Priority values are serviced in ascending order (e.g. 0 is
higher priority than 1. Minimum: 7).
Synopsis: A string
A description for this configuration item.
Section 16.2.1, "Enabling and Configuring Traffic
Traffic Control and Classification
Description
Control".
Chapter 16
699