Siemens RUGGEDCOM ROX II User Manual page 326

Chapter 8
Layer 2
Clearing All Cable Diagnostic Statistics
To clear the statistics, type:
switch clear-cable-stats-all
Clearing Cable Diagnostic Statistics for a Specific Switchport
To clear only the statistics for a specific switchport, type:
interfaces switch slot port diagnostics clear-cable-stats-port
interfaces switch swport port diagnostics clear-cable-stats-port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Section 8.2
Managing Ethernet Trunk Interfaces
This section describes how to configure and manage Ethernet trunk interfaces.
CONTENTS
• Section 8.2.1, "Viewing a List of Ethernet Trunk Interfaces"
• Section 8.2.2, "Adding an Ethernet Trunk Interface"
• Section 8.2.3, "Deleting an Ethernet Trunk Interface"
• Section 8.2.4, "Managing Ethernet Trunk Ports"
Section 8.2.1
Viewing a List of Ethernet Trunk Interfaces
To view a list of Ethernet trunk interfaces, type:
show running-config interface trunk
If trunks have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface trunks
interface
trunks 1
switchport
no alias
no mcast-filtering gmrp
no cos inspect-tos
vlan pvid 1
no vlan gvrp-mode
trunk-ports lm6 1
!
trunk-ports lm6 2
!
no spanning-tree restricted-role
no spanning-tree restricted-tcn
280
RUGGEDCOM ROX II
CLI User Guide
Managing Ethernet Trunk Interfaces