Siemens RUGGEDCOM ROX II User Manual page 598

Chapter 13
Unicast and Multicast Routing
If LDP discovery interfaces have been configured, a table similar to the following example appears:
ruggedcom# show mpls ldp status discovery
status discovery
local id 4.4.4.4
interfaces
INTERFACE SRC IP ADDR
---------------------------------------------------------
switch.0010 192.168.10.2
switch.0020 192.168.20.1
This table provides the following information:
Parameter
interface
src-ip-addr
peer-id
peer-ip
state
For more information about configuring LDP discovery interfaces, refer to
an LDP Interface".
Section 13.10.7.3
Viewing the Status of the LDP Neighbor Local Node Information
To view the status of the local node(s) for the LDP neighbor on the device, type:
show mpls ldp status neighbor local-node-information
A table or list similar to the following example appears:
ruggedcom# show mpls ldp status neighbor local-node-information
LDP ID HOLDTIME
------------------------------
4.4.4.4 15s
This table or list provides the following information:
Parameter
ldp-id
hello-holdtime
session-holdtime
552
PEER ID PEER IP
2.2.2.2 192.168.10.1
6.6.6.6 192.168.20.2
Synopsis: A string
The LDP discovery interface.
Synopsis: A string
The LDP discovery source IP address.
Synopsis: A string
The LDP discovery peer ID.
Synopsis: A string
LDP discovery peer IP address
Synopsis: A string
The LDP discovery interface state.
KEEPALIVE
INTERVAL
180s
Synopsis: A string
The LDP ID of the neighbor local node.
Synopsis: A string
LDP hello holdtime of the neighbor local node.
Synopsis: A string
The LDP session holdtime of the neighbor local node.
STATE
OPER
OPER
Description
Section 13.10.7.9, "Enabling/Disabling
Description
Viewing the Status of the LDP Neighbor Local Node
RUGGEDCOM ROX II
CLI User Guide
Information