Siemens RUGGEDCOM ROX II User Manual page 105

RUGGEDCOM ROX II
CLI User Guide
Parameter
Section 4.2.4
Viewing CPU/RAM Utilization
To view the CPU/RAM utilization statistics for each module installed in the device, type:
show chassis cpu slot-cpu
A table or list similar to the following example appears:
ruggedcom# show chassis cpu slot-cpu | tab
SLOT DETECTED MODULE
-------------------------------------------------------------------------
lm3 16x 10/100TX RJ45
cm RX5000 Control Module
sm SM 8 Gigabit Layer 2 w/ 2x 10/100/1000TX RJ45
lm4 8x 100FX SFP
This table or list provides the following information:
Parameter
slot
detected-module
cpu-load
ram-avail
ram-avail-low
Section 4.2.5
Viewing the Slot Status
To view the overall status of each slot, type:
show chassis status slot-status
A table or list similar to the following example appears:
ruggedcom# show chassis status slot-status | tab
START
Viewing CPU/RAM Utilization
This parameter is mandatory.
CPU
LOAD
0
17
0
8
Synopsis: { { --- }{ pm1, pm2, main }{ sm, lm1, lm2, lm3, lm4, lm5, lm6, swport, eth,
serport, celport, wlanport }{ cm, em }{ trnk } }
The slot name, as marked on the silkscreen across the top of the chassis.
Synopsis: A string 1 to 60 characters long
The installed module's type specifier.
This parameter is mandatory.
Synopsis: A 32-bit signed integer between 0 and 100
The CPU load, in percent, on the installed module.
Synopsis: A 32-bit signed integer between 0 and 100
The proportion of memory (RAM) currently unused, in percent, on the installed module.
Synopsis: A 32-bit signed integer between 0 and 100
The lowest proportion of unused memory (RAM), in percent, recorded for the installed
module since start-up.
Description
RAM
RAM AVAIL
AVAIL LOW
74 70
59 57
74 71
74 70
Description
STATUS
Chapter 4
Device Management
59