Siemens RUGGEDCOM ROX II User Manual page 243

RUGGEDCOM ROX II
CLI User Guide
!
If no hosts have been configured, add hosts as needed. For more information, refer to
Host".
Section 6.9.11.2
Adding a Host
To add a new host for a firewall, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the host by typing:
security firewall fwconfig firewall fwhost name
Where:
• firewall is the name of the firewall
• name is the name of the host
3. Configure the host by typing the following commands:
Parameter
ipsec
Parameter
iptype { iptype }
zone { zone }
interface { interface }
ipaddress { ipaddress }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 6.9.11.3
Deleting a Host
To delete a host, do the following:
Adding a Host
Synopsis: { true, false }
Default: false
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
Synopsis: A string
A pre-defined zone
This parameter is mandatory.
Synopsis: A string
A pre-defined interface to which optional IPs and/or networks can be added.
This parameter is mandatory.
Synopsis: A string
Additional IP addresses or networks - comma separated, or a range in the form of
low.address-high.address
Synopsis: A string
(Optional) The description string for this host.
Section 6.9.11.2, "Adding a
Description
Description
Chapter 6
Security
197