Siemens RUGGEDCOM ROX II User Manual page 510

Chapter 13
Unicast and Multicast Routing
Parameter
from
tag
time
If no dynamic RIP routes have been configured, configure RIP and add routes as needed. For more information
about configuring RIP, refer to
Section 13.7.3
Managing Prefix Lists and Entries
Neighbors can be associated with prefix lists, which allow the RIPs daemon to filter incoming or outgoing routes
based on the allow and deny entries in the prefix list.
CONTENTS
• Section 13.7.3.1, "Viewing a List of Prefix Lists"
• Section 13.7.3.2, "Viewing a List of Prefix Entries"
• Section 13.7.3.3, "Adding a Prefix List"
• Section 13.7.3.4, "Adding a Prefix Entry"
• Section 13.7.3.5, "Deleting a Prefix List"
• Section 13.7.3.6, "Deleting a Prefix Entry"
Section 13.7.3.1
Viewing a List of Prefix Lists
To view a list of prefix lists for dynamic RIP routes, type:
show running-config routing rip filter prefix-list
If prefix lists have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip filter prefix-list | tab
NAME
-------------------------------------------------------------------------
list-permit-lan-22
list-withdraw-lan-11
!
If no prefix lists have been configured, add lists as needed. For more information, refer to
"Adding a Prefix List".
464
Synopsis: A string
Where this route comes from.
Synopsis: A string
Tag.
Synopsis: A string
The route update time.
Section 13.7.1, "Configuring
DESCRIPTION SEQ ACTION
-
100 permit
-
100 permit
200 permit
Description
RIP".
SUBNET LE GE
192.168.33.0/24 - -
192.168.33.0/24 - -
192.168.33.0/24 32 -
RUGGEDCOM ROX II
CLI User Guide
Section 13.7.3.3,
Managing Prefix Lists and Entries