Siemens RUGGEDCOM ROX II User Manual page 398

Chapter 10
Serial Server
Section 10.7.2
Adding a Remote Host Interface
NOTE
A maximum of ten interfaces are permitted for each remote host.
To add a remote host interface for a serial port using the raw socket protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to:
interface serial slot port protocols rawsocket setrawsocket remote-host remote-host interface
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• remote-host is the remote host
3. Configure the following parameter(s) as required:
Parameter
{ name }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 10.7.3
Deleting a Remote Host Interface
To delete a remote host interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the remote host by typing:
no interface serial slot port protocols rawsocket setrawsocket remote-host remote-host interface
interface name
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• remote-host is the remote host
• interface name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
352
Synopsis: A string
The transmitting interface's name for the destination multicast group IP address and
remote port.
Description
Adding a Remote Host Interface
RUGGEDCOM ROX II
CLI User Guide