Siemens RUGGEDCOM ROX II User Manual page 112

Chapter 4
Device Management
Section 4.8.2
Installing Feature Keys
When installing a new feature key, RUGGEDCOM ROX II evaluates the new file-based feature key and the device
feature key and enables the most capable feature level described by the keys.
Feature keys can be installed from a host computer or USB Mass Storage drive.
Installing From a Host Computer
NOTE
Before installing a feature key from a host computer, the following information is required:
• The file name of the feature key
• The user name and password required to log into the host computer where the feature key is stored
• The host name or IP address of the computer where the feature key is stored
1. Make sure the CLI is in Operational mode.
2. Install the feature key by typing:
file scp-featurekey-from-url username@host:/path/current-filename new-filename
Where:
• username is the name of a user who can log into the computer where the feature key file is stored.
• host is the hostname or IP address of the computer where the feature key file is stored.
• path is the directory path to the feature key file in the host computer.
• current-filename is the current name of the feature key file.
• new-filename is the new name of the feature key file on the device. This parameter is optional. The
current filename will be used if a new filename is not provided.
For example:
file scp-featurekey-from-url wsmith@10.200.10.39:/files/keys/L3SE_cmRUMHD06096338.key
L3SE_cmRUMHD06096338.key
3. When prompted, type the user's password and then press Enter. The system uploads the feature key file:
ruggedcom# file scp-featurekey-from-url wsmith@10.200.20.39:/files/keys/
L3SE_cmRUMHD06096338.key L3SE_cmRUMHD06096338.key
wsmith@10.200.20.39's password:
L3SE_cmRUMHD06096338.key
Installing From a USB Mass Storage Drive
1. Make sure the CLI is in Operational mode.
2. Insert the USB Mass Storage drive into the USB port on the device. For more information, refer to the
RUGGEDCOM RX5000/MX5000/MX5000RE Installation Guide.
3. Install the feature key by typing:
file scp-featurekey-from-url usb:///path/current-filename new-filename
Where:
66
100% 192 0.2KB/s 00:00
Installing Feature Keys
RUGGEDCOM ROX II
CLI User Guide