Siemens RUGGEDCOM ROX II User Manual page 635

RUGGEDCOM ROX II
CLI User Guide
Section 13.13.2.2
Adding a Static Multicast Group
To add a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the multicast group by typing:
routing multicast static mcast-groups description
Where:
• description is the name of the multicast group. Up to 32 characters are allowed, excluding spaces.
3. Configure the following parameter(s) as required:
Parameter
{ description }
4. Configure out-interfaces. Refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 13.13.2.3
Deleting a Static Multicast Group
To delete a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the multicast group by typing:
no routing multicast static mcast-groups description
Where:
• description is the name of the multicast group to be deleted
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.13.3
Managing Out-Interfaces
An out-interface is the interface to which multicast packets are forwarded. Multiple out-interfaces can be defined
for each static multicast group.
CONTENTS
• Section 13.13.3.1, "Viewing a List of Out-Interfaces"
• Section 13.13.3.2, "Adding an Out-Interface"
• Section 13.13.3.3, "Deleting an Out-Interface"
Adding a Static Multicast Group
Synopsis: A string 1 to 32 characters long
Describes the multicast group, spaces are not allowed.
Section 13.13.3.2, "Adding an
Unicast and Multicast Routing
Description
Out-Interface".
Chapter 13
589