Siemens RUGGEDCOM ROX II User Manual page 158

Chapter 5
System Administration
Rights
Run Commands
CAUTION!
Security hazard – risk of unauthorized access and/or exploitation. To prevent unauthorized access to
the device, make sure to change the default passwords for all users before commissioning the device.
For more information, refer to
CONTENTS
• Section 5.8.1, "Viewing a List of Users"
• Section 5.8.2, "Adding a User"
• Section 5.8.3, "Deleting a User"
• Section 5.8.4, "Monitoring Users"
Section 5.8.1
Viewing a List of Users
To view a list of user accounts, type:
show running-config admin users
If users have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin users | tab
admin
users
userid
NAME PASSWORD
----------------------------------------------------------
admin $1$LmRO$j7/q/wtlwjfUvbOVrbt4o.
guest $1$uGztU0$6b7YS6gqwtrelTzA/2noQ. guest
oper $1$eSsFfFMh$NEHgTHsU1T4RRz8sXNV2F1
If no user accounts have been configured, add user accounts as needed. For more information, refer to
Section 5.8.2, "Adding a
Section 5.8.2
Adding a User
To add a new user account, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the user account by typing:
admin users userid name role role
Where:
• name is the name of the user account
112
Guest
û
Section 5.9.2, "Setting a User
ROLE
administrator
operator
User".
User Type
Operator
û
Password/Passphrase".
RUGGEDCOM ROX II
CLI User Guide
Admin
ü
Viewing a List of Users