Siemens RUGGEDCOM ROX II User Manual page 728

Chapter 15
Network Discovery and Management
GROUP MODEL
------------------------------------------------------------------------
initial any
initial any
initial any
testgroup v2c
all-rights any
!
!
If no SNMP groups have been configured, add groups as needed. For more information, refer to
"Adding an SNMP Group".
Section 15.2.9.2
Adding an SNMP Group
To add an SNMP group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the SNMP group by typing:
admin snmp snmp-access group model level
Where:
• group is the name of the group.
• model is the security model for the group. Options include: any, v1, v2c, or v3.
• level is the security level for the group. Options include:
▫ authPriv – Communication with authentication and privacy.
▫ authNoPriv – Communication with authentication and without privacy.
▫ noAuthnoPriv – Communication without authentication and privacy.
3. Configure the following parameter(s) as required:
Parameter
read-view-name { read-view-name }
write-view-name { write-view-name }
notify-view-name { notify-view-name }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
682
LEVEL NAME
noAuthNoPriv all-of-mib
authNoPriv all-of-mib
authPriv all-of-mib
noAuthNoPriv all-of-mib
noAuthNoPriv all-of-mib
Synopsis: { no-view, v1-mib, restricted, all-of-mib }
Default: all-of-mib
The name of the read view to which the SNMP group has access: all-of-mib, restricted,
v1-mib, or no-view.
Synopsis: { no-view, v1-mib, restricted, all-of-mib }
Default: all-of-mib
The name of the write view to which the SNMP group has access: all-of-mib, restricted,
v1-mib, or no-view.
Synopsis: { no-view, v1-mib, restricted, all-of-mib }
Default: all-of-mib
The name of the notification view to which the SNMP group has access: all-of-mib,
restricted, v1-mib, or no-view.
NAME VIEW NAME
all-of-mib all-of-mib
all-of-mib all-of-mib
all-of-mib all-of-mib
all-of-mib all-of-mib
all-of-mib all-of-mib
Description
RUGGEDCOM ROX II
CLI User Guide
Section 15.2.9.2,
Adding an SNMP Group