Siemens RUGGEDCOM ROX II User Manual page 360

Chapter 8
Layer 2
Where:
• name is the name of the static VLAN
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 8.5.6.3
Deleting a Forbidden Port
To delete a forbidden port, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to switch » vlans » static-vlan » {name} » forbidden-ports, where {name} is the name of the static
2.
VLAN.
3. Configure the following parameter(s) as required:
no switch vlans static-vlan name forbidden-ports slot port
Where:
• name is the name of the static VLAN
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 8.5.7
Managing VLANs for Interfaces and Tunnels
This section describes how to view, add and delete tunnels for specific interfaces and tunnels.
• Section 12.1.8, "Managing VLANs for Virtual Switches"
• Section 12.4.6, "Managing VLANs for L2TPv3 Tunnels"
• Section 4.18.3, "Managing VLANs for Routable Ethernet Ports"
314
RUGGEDCOM ROX II
CLI User Guide
Deleting a Forbidden Port