Siemens RUGGEDCOM ROX II User Manual page 572

Chapter 13
Unicast and Multicast Routing
2. Add the list by typing:
• For Standard OSPF Routes
routing ospf filter prefix-list name
• For VRF Routes via OSPF
routing ospf vrf vrf filter prefix-list name
Where:
• vrf is the name of the chosen VRF
• name is the name of the prefix list
3. Configure the following parameter(s) as required:
Parameter
description { description }
4. Add prefix entries as needed. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 13.9.4.4
Adding a Prefix Entry
To add an entry for a dynamic OSPF prefix list, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the entry by typing:
• For Standard OSPF Routes
routing ospf filter prefix-list name entry number
• For VRF Routes via OSPF
routing ospf vrf vrf filter prefix-list name entry number
Where:
• vrf is the name of the chosen VRF
• name is the name of the prefix list
• number is the sequence number for the entry
3. Configure the following parameter(s) as required:
Parameter
action { action }
subnet { subnet }
le { le }
526
Synopsis: A string 1 to 1024 characters long
The description of the prefix list.
Section 13.9.4.4, "Adding a Prefix
Synopsis: { deny, permit }
Default: permit
Action.
Synopsis: A string 9 to 18 characters long
Network (xxx.xxx.xxx.xxx/xx).
This parameter is mandatory.
Synopsis: An 8-bit unsigned integer between 1 and 32
The maximum prefix length to match ipaddress within subnet.
Description
Description
Adding a Prefix Entry
RUGGEDCOM ROX II
CLI User Guide
Entry".