Siemens RUGGEDCOM ROX II User Manual page 606

Chapter 13
Unicast and Multicast Routing
7. Configure one or more IP/VPN tunnels for each interface. For more information, refer to
"Adding an IP/VPN
8. Add one or more BGP neighbors to the VPNv4 address family. For more information, refer to
Section 13.11.9.2, "Adding a
9. Verify the network configuration.
VRF-Lite Configuration
1. Make sure BGP is enabled and configure the Autonomous System ID for the Border Gateway Protocol (BGP).
For more information, refer to
2. Configure a VRF definition and route targets for each Customer Edge (CE) router. For more information, refer
to Section 13.11.5.2, "Adding a VRF
3. Configure a routable interface and IP address for each VRF definition. For more information, refer to
Section 13.11.4, "Configuring a VRF
4. Enable OSPF. For more information, refer to
5. Configure one or more VRF instances for OSPF. For more information, refer to
OSPF".
6. Configure an IPv4 address family for each VRF instance. For more information, refer to
"Adding an IPv4 Address
7. Configure one or more static VRF routes. For more information, refer to
VRF Route".
8. Verify the network configuration.
Section 13.11.4
Configuring a VRF Interface
Each VRF definition must be associated with at least one routable interface that has been assigned an IP address.
To configure a routable interface to forward VRF traffic for a specific VRF definition, do the following:
1. Make sure the CLI is in Configuration mode.
2. Set the costing by typing:
ip interface vrf-forwarding vrf
Where:
• interface is the name of the routable interface
• vrf is the desired VRF instance
3. Configure an IPv4 or IPv6 address for the interface. For more information, refer to
IPv4 Address" or
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
560
Tunnel".
Neighbor".
Section 13.8.1, "Configuring
Definition".
Interface".
Family".
Section 7.1.4.2, "Adding an IPv6
BGP".
Section 13.9.2, "Configuring
Address".
Section 13.11.8.2,
OSPF".
Section 13.9.2, "Configuring
Section 13.11.10.2,
Section 13.11.13.2, "Adding a Static
Section 7.1.3.2, "Adding an
Configuring a VRF Interface
RUGGEDCOM ROX II
CLI User Guide