Siemens RUGGEDCOM ROX II User Manual page 628

Chapter 13
Unicast and Multicast Routing
Section 13.12.2
Adding an IPv4 Static Route
To add an IPv4 static route, do the following:
1. Make sure the CLI is in Configuration mode.
IMPORTANT!
If the route is to be configured as a black hole route, make sure the subnet matches that of
another static route. The black hole route will then act as a backup should the other static route go
down.
2. Add the IPv4 static route by typing:
routing ipv4 route subnet
Where:
• subnet is the subnet (network/prefix) of the static route
3. If the device has a Layer 3 switch installed, configure the following parameter(s) as required:
NOTE
Only TCP and UDP traffic flows will be accelerated by the IP/Layer 3 switch fabric. Non-IP packet
types, such as ICMP and IGMP, will not be accelerated.
Parameter
hw-accelerate
4. [Optional] Configure the route as a black hole route. For more information, refer to
"Configuring a Black Hole Connection for an IPv4 Static
5. [Optional] If the static route is not a black hole route, configure either the interface that connects to the next-
hop router (if there is a direct connection) or the IP address (gateway) of the next-hop router. Only one can
be configured per static route. For more information, refer to either
an IPv4 Static Route"
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 13.12.3
Adding an IPv6 Static Route
To add an IPv6 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the IPv6 static route by typing:
routing ipv6 route subnet
Where:
• subnet is the subnet (network/prefix) of the static route
582
If the static unicast route can be hardware accelerated, this option will be available.
For a static unicast route to be accelerated, the ingress and egress interfaces must be
switched.
or Section 13.12.7.3, "Adding an Interface for an IPv4 Static
Description
Route".
Section 13.12.6.3, "Adding a Gateway for
RUGGEDCOM ROX II
CLI User Guide
Section 13.12.5,
Route".
Adding an IPv4 Static Route