Siemens RUGGEDCOM ROX II User Manual page 300

Chapter 7
IP Address Assignment
dhcpserver6
subnet6-name sub2
options
prefix6 2001:db8:28d2:f0::
end 2001:db8:28d2:f0::
bits 60
!
!
!
!
!
If no prefixes have been configured, add ranges as needed. For more information, refer to
"Adding an IPv6 Prefix".
Section 7.3.15.2
Adding an IPv6 Prefix
To add a prefix, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the prefix by typing:
services dhcpserver6 subnet6-name name options prefix6 prefix
Where:
• name is the name of the subnet
• prefix is the starting IPv6 prefix delegation
3. Configure the IPv6 Range Configuration by configuring the following parameter(s) as required:
Parameter
end { end }
bits { bits }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 7.3.15.3
Deleting an IPv6 Prefix
To delete a prefix, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the prefix by typing:
no services dhcpserver6 subnet6-name name options prefix6 prefix
Where:
• name is the name of the subnet
254
Synopsis: A string 6 to 40 characters long
The ending IPv6 prefix delegation that the server uses to offer to the client.
This parameter is mandatory.
Synopsis: An 8-bit unsigned integer between 1 and 64
Prefix delegations of bits length that are offered to the client.
This parameter is mandatory.
Section 7.3.15.2,
Description
Adding an IPv6 Prefix
RUGGEDCOM ROX II
CLI User Guide