Siemens RUGGEDCOM ROX II User Manual page 128

Chapter 4
Device Management
IMPORTANT!
RUGGEDCOM ROX II only accepts configuration files from devices with the same hardware profile
running the same software version. It is recommended to only load configuration files from the same
device.
1. [Optional] Install the configuration file on the device. For more information, refer to
Files".
2. Load the configuration file by typing:
admin full-configuration-load format cli file-name filename
Where:
• filename is the name of the configuration file
A confirmation message appears. Type yes to load the file or no to abort.
3.
Section 4.12
Upgrading/Downgrading the RUGGEDCOM ROX II
Software
This section describes how to change the version of RUGGEDCOM ROX II running on the device.
CONTENTS
• Section 4.12.1, "Configuring the Upgrade Source"
• Section 4.12.2, "Setting Up an Upgrade Server"
• Section 4.12.3, "Upgrading the RUGGEDCOM ROX II Software"
• Section 4.12.4, "Stopping/Declining a Software Upgrade"
• Section 4.12.5, "Downgrading the RUGGEDCOM ROX II Software"
Section 4.12.1
Configuring the Upgrade Source
Firmware for upgrading or downgrading RUGGEDCOM ROX II can be uploaded from either an upgrade server or
a portable USB Mass Storage drive. For information about setting up an upgrade server, refer to
"Setting Up an Upgrade
IMPORTANT!
A Trusted Root CA (Certified Authority) certificate is required if using HTTPS to upload packages from
an upgrade server. The certificate is chosen using the Server CA parameter. If a certificate is not
available, it must be uploaded to the device. For more information, refer to
CA Certificate and
To specify the source of the RUGGEDCOM ROX II software and a specific version, do the following:
1. Make sure the CLI is in Configuration mode.
82
Server".
CRL".
Upgrading/Downgrading the RUGGEDCOM ROX II Software
RUGGEDCOM ROX II
CLI User Guide
Section 4.9.1, "Installing
Section 4.12.2,
Section 6.8.4.3, "Adding a