Siemens RUGGEDCOM ROX II User Manual page 643

RUGGEDCOM ROX II
CLI User Guide
and/or the RP assignment does not change often. It is important though that all static RP addresses be mirrored on
all PIM-SM enabled devices in the multicast domain.
CONTENTS
• Section 13.14.8.1, "Viewing a List of Static RP Addresses "
• Section 13.14.8.2, "Adding a Static RP Address"
• Section 13.14.8.3, "Deleting a Static RP Address"
Section 13.14.8.1
Viewing a List of Static RP Addresses
To view a list of static RP addresses, type:
show running-config routing multicast dynamic pim-sm rp-address
If addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing multicast dynamic pim-sm rp-address | tab
ADDRESS GROUP
---------------------------------------
172.30.145.254 225.0.2.6/8
192.168.0.10 225.0.0.1/8
!
If no addresses have been configured, add addresses as needed. For more information, refer to
"Adding a Static RP
Section 13.14.8.2
Adding a Static RP Address
To add a static RP address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the RP address by typing:
routing multicast dynamic pim-sm rp-address static-address group-address priority priority
Where:
• static-address is the IP address of the RP
• group-address is the multicast address of the group handled by the RP
• priority is the the RP's priority in the election process
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.14.8.3
Deleting a Static RP Address
To delete a static RP address, do the following:
1. Make sure the CLI is in Configuration mode.
Viewing a List of Static RP Addresses
PRIORITY
-
-
Address".
Chapter 13
Unicast and Multicast Routing
Section 13.14.8.2,
597