Siemens RUGGEDCOM ROX II User Manual page 106

Chapter 4
Device Management
SLOT DETECTED MODULE
START DATE TIME
--------------------------------------------------------------------------------------------------------------------
pm1 none
2017-01-12Z 03:19:16Z
lm1 none
2017-01-11Z 10:22:45Z
lm2 none
2017-01-11Z 10:25:15Z
lm3 16x 10/100TX RJ45
2017-01-11Z 10:25:14Z
cm RX5000 Control Module
2017-01-12Z 03:19:16Z
sm SM 8 Gigabit Layer 2 w/ 2x 10/100/1000TX RJ45
2017-01-11Z 10:25:16Z
lm4 8x 100FX SFP
2017-01-11Z 10:25:13Z
lm5 none
2017-01-11Z 10:22:45Z
lm6 none
2017-01-11Z 10:22:45Z
pm2 Power 88-300VDC or 85-264VAC w/ screw terminal block
2017-01-12Z 03:19:16Z
em none
2017-01-12Z 03:19:16Z
This table or list provides the following information:
Parameter
slot
detected-module
state
status-string
uptime
start-date
start-time
60
Synopsis: { { --- }{ pm1, pm2, main }{ sm, lm1, lm2, lm3, lm4, lm5, lm6, swport, eth,
serport, celport, wlanport }{ cm, em }{ trnk } }
The slot name, as marked on the silkscreen across the top of the chassis.
Synopsis: A string 1 to 60 characters long
The installed module's type specifier.
This parameter is mandatory.
Synopsis: { unknown, empty, disabled, resetting, operating, failed, disconnected }
The current state of the installed module.
This parameter is mandatory.
Synopsis: A string
The runtime status of the installed module.
This parameter is mandatory.
Synopsis: A string
The total time elapsed since the start-up of the installed module.
This parameter is mandatory.
Synopsis: A string
The date on which the installed module was started up.
This parameter is mandatory.
Synopsis: A string
The time at which the installed module was started up.
This parameter is mandatory.
STATE STRING UPTIME
empty ---- N/A
empty ---- 0D 0hr 0min 0sec
empty ---- 0D 0hr 0min 0sec
operating Normal 1D 6hr 28min 46sec
operating Normal 1D 6hr 33min 12sec
operating Normal 1D 6hr 28min 46sec
operating Normal 1D 6hr 28min 45sec
empty ---- 0D 0hr 0min 0sec
empty ---- 0D 0hr 0min 0sec
operating Normal N/A
empty ---- N/A
Description
RUGGEDCOM ROX II
CLI User Guide
Viewing the Slot Status