Siemens RUGGEDCOM ROX II User Manual page 568

Chapter 13
Unicast and Multicast Routing
Parameter
opaque-lsa
passive-default
refresh-timer { refresh-timer }
router-id { router-id }
3. Configure prefix list filters. For more information, refer to
4. Configure areas. For more information, refer to
5. Configure route map filters. For more information, refer to
6. Configure redistribution metrics. For more information, refer to
Metric".
7. Configure interfaces. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Section 13.9.3
Viewing the Status of Dynamic OSPF Routes
To view the status of the dynamic OSPF routes configured on the device, type:
show routing status ospf route network
If OSPF routes have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status ospf route network | tab
ID DISCARD
---------------------------------------------------------------------------------
192.168.1.0/24 no
192.168.2.0/24 no
This list provides the following information:
Parameter
id
destination
path-type
cost
522
Enables the Opaque-LSA capability (RFC2370).
Synopsis: { true, false }
Default: true
Default passive value for new interface.
Synopsis: A 16-bit unsigned integer between 10 and 1800
Default: 10
The refresh timer.
Synopsis: A string 7 to 15 characters long
The Router ID for OSPF.
INTER AREA COST AREA
intra area 10 0.0.0.0
intra area 10 0.0.0.0
Synopsis: A string
Network Prefix.
Synopsis: A string
Destination (network or discard).
Synopsis: A string
Path type (inter-area or intra-area).
Synopsis: A string
Cost.
Description
Section 13.9.4.3, "Adding a Prefix
Section 13.9.5.2, "Adding an
Section 13.9.6.3, "Adding a Route Map
Section 13.9.8.2, "Adding a Redistribution
Section 13.9.9.2, "Configuring a Routing
HOW
directly attached to fe-1-2
directly attached to fe-1-4
Description
Viewing the Status of Dynamic OSPF Routes
RUGGEDCOM ROX II
CLI User Guide
List".
Area".
Filter".
Interface".